Toyota SIENNA 2022 Manual page 149

148
3-2. Opening, closing and locking the doors
NOTICE
● Take care not to damage the
sensors (installed on the front
edge of the power sliding door)
with a knife or other sharp
object.
● Make sure there is nothing in
the doorway before closing.
● Do not close the sliding door by
applying the brakes. Doing so
could cause the sliding door to
be damaged.
■ Hands Free Power Sliding
Doors precautions (if
equipped)
The kick sensors are located
behind the portions with labels on
the rocker mouldings. Observe
the following to ensure that the
Hands Free Power Sliding Door
function operates properly:
● Keep the portions with labels on
the rocker mouldings clean at all
times.
If the portions with labels on the
rocker mouldings are dirty or
covered with snow or mud, the
kick sensors may not operate.
In this situation, clean off the dirt
or snow, move the vehicle from
the current position and then
check if the kick sensors oper-
ate.
If they do not operate, have the
vehicle inspected by your
Toyota dealer.
● Do not apply coatings that have
a rain clearing (hydrophilic)
effect, or other coatings, to the
portions with labels on the
rocker mouldings.
● Do not park the vehicle near
objects that may move and con-
tact portions with labels on the
rocker mouldings, such as
grass or trees.
If the vehicle has been parked
for a while near objects that
may move and contact the por-
tions with labels on the rocker
mouldings, such as grass or
trees, the kick sensors may not
operate. In this situation, move
the vehicle from the current
position and then check if the
kick sensors operate. If they do
not operate, have the vehicle
inspected by your Toyota
dealer.
● Do not subject the kick sensors
or their surrounding areas to a
strong impact.
If the kick sensors or their sur-
rounding areas have been sub-
jected to a strong impact, the
kick sensors may not operate
properly. If the kick sensors do
not operate in the following situ-
ations, have the vehicle
inspected by your Toyota
dealer.
• The kick sensors or their sur-
rounding areas have been sub-
jected to a strong impact.
• The portions with labels on the
rocker mouldings are scratched
or damaged.
● Do not disassemble the rocker
mouldings.
● Do not attach an accessory con-
taining metal or apply metallic
paint to the rocker mouldings.
Canceling the power slid-
ing door system
The power sliding door system
can be enabled/disabled by
using the power sliding door