Table of Contents
Advertisement
452
6-3. Do-it-yourself maintenance
3
Remove the light bulb.
4
Install a new light bulb.
5
Install the lens.
A
Hooks
1
Fit the lens into either the
right or left hooks.
2
Push the lens into place.
After installation, confirm that the
lens is properly installed by gently
pulling it.
6
Install the cover.
WARNING
■
Replacing light bulb
●
Turn off the light. Do not attempt
to replace the bulb immediately
after turning off the light.
The bulb becomes very hot and
may cause burns.
●
Do not touch the glass portion
of the light bulb with bare
hands. When it is unavoidable
to hold the glass portion, use
and hold with a clean dry cloth
to avoid getting moisture and
oils on the bulb.
Also, if the bulb is scratched or
dropped, it may blow out or
crack.
●
Fully install light bulb and any
parts used to secure it. Failure
to do so may result in heat dam-
age, fire, or water entering the
light unit. This may damage the
light or cause condensation to
build up on the lens.
Advertisement
Chapters
Table of Contents
