Toyota SIENNA 2022 Manual page 392

392
5-4. Using the other interior features
needed to complete rolling code
programming.
1
Locate the "Learn" or "Smart"
button on the garage door
opener motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by
manufacturer. Refer to the owner's
manual supplied with the garage
door opener motor for details.
2
Press and release the
"Learn" or "Smart" button.
3
Perform within 30 seconds after
performing 2.
3
Press and hold the desired
®
HomeLink
vehicle) for 2 seconds and
release it. Repeat this
sequence
(press/hold/release) up to 3
times to complete program-
ming.
button (inside the
If the garage door opener
motor operates when the
®
HomeLink button is
pressed, the garage door
opener motor recognizes the
®
HomeLink signal.
Enabling 2-way communi-
■
cation with a garage door
(only available for compati-
ble devices)
When enabled, 2-way communi-
cation allows you to check the
status of the opening and clos-
ing of a garage door through
indicators in your vehicle.
2-way communication is only
available if the garage door
opener motor used is a compati-
ble device. (To check device
compatibility, refer to
www.homelink.com.)
1
Within 5 seconds after pro-
gramming the garage door
opener has been completed,
if the garage door opener
motor is trained to
®
HomeLink , both garage
door operation indicators will
flash rapidly (green) and the
light on the garage door