Toyota SIENNA 2022 Manual page 144

Table of Contents

Advertisement

The situations in which the slid-
ing door does not open com-
pletely
The left side sliding door does not
open completely when the fuel filler
door is opened.
Jam protection function
Sensor
is attached to the front
A
edge of the power sliding door. If
any object obstructs the power slid-
ing door when closing, the power
sliding door will stop after reversing
approximately 3.9 in. (10 cm).
Sliding door reserve lock func-
tion
This function is a function which
reserves locking of all doors before-
hand, when the power sliding door
is open.
When the following procedure is
performed, all the doors except the
power sliding door are locked and
then power sliding door will also be
locked at the same time it is closed.
1
Close all doors, except the
power sliding door.
2
During the power sliding door
closing operation, lock the doors
using the smart key system from
the front doors (P.132) or the
wireless remote control.
(P.132)
3-2. Opening, closing and locking the doors
A buzzer sounds and the emer-
gency flashers flash to indicate that
all the doors have been closed and
locked.
If the electronic key is placed
inside the vehicle after starting a
close operation via the door
reserve lock function, the elec-
tronic key may become locked
inside the vehicle. Make sure to
always carry the electronic key on
your person.
If the power sliding door does not
fully close due to the operation of
the jam protection function, etc.,
while the sliding door is automati-
cally closing after a door reserve
lock operation is performed, the
door reserve lock function is can-
celed and all the doors will unlock.
Before leaving the vehicle, make
sure that all the doors are closed
and locked.
Power sliding door brake func-
tion
When the power sliding door
detects an abnormality and stops
operating, power sliding door brake
function may be activated. When
brake function is activated, door
movement is restricted by the brake
and motion may appear to be not
smooth. This is not malfunction.
Move the door to fully closed posi-
tion to reset the system and normal
power sliding door function will
resume.
Sliding door closer
In the event that the sliding door is
left slightly open, the sliding door
closer will automatically close it to
the fully closed position.
Power sliding door operation
Wireless remote control: Even if the
door is locked, pressing and holding
the sliding door buttons will unlock
all doors and start open operation.
143
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sienna 2021

Table of Contents