Toyota SIENNA 2022 Manual page 145

144
3-2. Opening, closing and locking the doors
■ If the power sliding door is
inoperative
When the power sliding door
detects an abnormality and stops
opening and can not be completely
closed manually, turn the inside lock
button to "LOCK" position to cancel
the function and close the door
manually. After that, have the vehi-
cle inspected and repaired by your
Toyota dealer.
■ Kick sensor operating condi-
tions (vehicles with Hands Free
Power Sliding Doors)
The Hands Free Power Sliding Door
will open/close automatically when
the following conditions are met:
● The kick sensor operation is
enabled (P.112)
● The front door (the same side of
the sliding door you open) is
closed.
● The electronic key is within the
operational range. (P.165)
● A foot is put under the portion with
a label on the rocker moulding
and moved away from the rocker
moulding.
The power sliding door may also
be operated by putting a hand, an
elbow, a knee, etc. under the por-
tion with a label on the rocker
moulding and moving it away from
the rocker moulding. Make sure to
put it close enough to the center
part of the rocker moulding.
■ Situations in which the Hands
Free Power Sliding Door may
not operate properly (vehicles
with Hands Free Power Sliding
Doors)
In the following situations, the
Hands Free Power Sliding Door
may not operate properly:
● When a foot remains under the
rocker moulding
● If the rocker moulding is strongly
hit with a foot or is touched for a
while
If the rocker moulding has been
touched for a while, wait for a short
time before attempting to operate
the Hands Free Power Sliding Door
again.
● When operated while a person is
too close to the rocker moulding
● When an external radio wave
source interferes with the commu-
nication between the electronic
key and the vehicle (P.166)
● When the vehicle is parked near
an electrical noise source which
affects the sensitivity of the Hands
Free Power Sliding Door, such as
a pay parking spot, gas station,
electrically heated road, or fluo-
rescent light
● When the vehicle is near a TV
tower, electric power plant, radio
station, large display, airport or
other facility that generates strong
radio waves or electrical noise
● When a large amount of water is
applied to the rocker moulding,
such as when the vehicle is being
washed or in heavy rain
● When mud, snow, ice, etc. is
attached to the rocker moulding
● When the vehicle has been
parked for a while near objects
that may move and contact the
rocker moulding, such as plants
● When an accessory is installed to
the rocker moulding
If an accessory has been installed,
turn the Hands Free Power Sliding
Door (kick sensor) operation setting
off.
■ Preventing unintentional opera-
tion of the Hands Free Power
Sliding Door (vehicles with
Hands Free Power Sliding
Doors)
When an electronic key is in the
operation range, the Hands Free
Power Sliding Door may operate
unintentionally, so be careful in the