Toyota SIENNA 2022 Manual page 182

■ Seat positions that can be
memorized (P.170)
The adjusted positions other than
the position adjusted by lumbar sup-
port switch can be recorded.
■ Operating the driving position
memory after turning the power
switch to OFF
Recorded seat positions can be
activated up to 180 seconds after
the driver's door is opened and
another 60 seconds after it is closed
again.
■ In order to correctly use the
driving position memory func-
tion
If a seat position is already in the
furthest possible position and the
seat is operated in the same direc-
tion, the recorded position may be
slightly different when it is recalled.
■ When recalling the driving posi-
tion
Take care when recalling the driving
position so that the head restraint
does not touch the ceiling.
■ If the 12-volt battery is discon-
nected
The memorized positions are
erased.
WARNING
■ Seat adjustment caution
Take care during seat adjustment
so that the seat does not strike
the rear passenger or squeeze
your body against the steering
wheel.
3-3. Adjusting the seats
Registering/recall/cancel-
ing a driving position to
an electronic key (mem-
ory recall function)
Registering procedure
■
Record your driving position to
button "1" or "2" before perform-
ing the following:
Carry only the key you want to
register, and then close the
driver's door.
If 2 or more keys are in the vehi-
cle, the driving position cannot
be recorded properly.
1
Check that the shift lever is in
P.
2
Turn the power switch to ON.
3
Recall the driving position
that you want to record.
4
While pressing the recalled
button, press and hold the
door lock switch (either lock
or unlock) until the buzzer
sounds.
If the button could not be regis-
tered, the buzzer sounds continu-
ously for approximately 3 seconds.
181
3