Toyota SIENNA 2022 Manual page 393

opener motor will blink twice,
indicating that 2-way commu-
nication is enabled.
If the indicators do not flash, per-
2 3
form and within the first 10
presses of the HomeLink
after programming has been com-
pleted.
2
Press a programmed
®
HomeLink button to oper-
ate a garage door.
3
Within 1 minute of pressing
the HomeLink
the garage door operation
has stopped, press the
"Learn" or "Smart" button on
the garage door opener
motor. Within 5 seconds of
the establishment of 2-way
communication with the
garage door opener, both
garage door operation indica-
tors in the vehicle will flash
rapidly (green) and the light
on the garage door opener
motor will blink twice, indicat-
ing that 2-way communica-
tion is enabled.
Reprogramming a single
■
®
HomeLink button
When the following procedure is
performed, buttons which
already have devices registered
to them can be overwritten:
1
Press and hold the desired
®
HomeLink button.
2
When the HomeLink
tor starts flashing orange,
5-4. Using the other interior features
®
button
®
button, after
®
indica-
release the HomeLink
ton and perform "Program-
ming HomeLink
20 seconds for the
®
HomeLink indicator to start
flashing).
■ Before programming
● Install a new battery in the trans-
mitter.
● The battery side of the transmitter
must be pointed away from the
®
HomeLink buttons.
Operating HomeLink
Press the appropriate
®
HomeLink button. The
®
HomeLink indicator light
should turn on.
The status of the opening and
closing of a garage door is
shown by the garage door oper-
ation indicators.
Vehicles with auto anti-glare

inside rear view mirror
Opening
A
Closing
B
393
®
but-
®
1
" (it takes
®
5