Changing Storage Media; Replacing A Hdd/Ssd - Siemens SIMATIC IPC427E Operating Instructions Manual

3. Remove the battery holder from the en-
closure guide.
4. Remove the battery from the battery
holder.
Procedure - Installation
Install the device by following the same steps in the reverse order.
7.3.2

Changing storage media

7.3.2.1

Replacing a HDD/SSD

This procedure applies to the replacement of the built-in HDD or SSD.
Requirement
• The device is disconnected from the power supply.
• The device is removed.
• 1 T10 screwdriver
Procedure
Note
Observe the guidelines for handling electrostatic-sensitive components in section "ESD
guideline (Page 79)".
SIMATIC IPC427E
Operating Instructions, 02/2021, A5E37454814-AE
Device maintenance and repair
7.3 Installing and removing hardware
67