Connecting Power Cables; Figure 4-21 Connecting The Connector Of The Ac Power Cable - Raisecom Gazelle S1000i-LI User Manual

Raisecom
Gazelle S1000i-LI (A) User Manual

4.4.3 Connecting power cables

Connecting AC power cable




The AC power cable of the Gazelle S1000i-LI is a 3-pin Phoenix connector. Connect the AC
power cable as below:
Step 1 Make the AC power cable according to specifications.
Step 2 Insert the AC power cable header into the power interface of the Gazelle S1000i-LI and
confirm full insertion, as shown in Figure 4-21.

Figure 4-21 Connecting the connector of the AC power cable

Step 3 Fastening screws of the AC power cable tightly, as shown in Figure 4-22.
Ensure the power type supported by the Gazelle S1000i-LI before installing the
power cable. Connect it with the voltage compliant with the printed voltage range
to the corresponding PINs. Otherwise, the Gazelle S1000i-LI will be damaged and
cannot be started normally.
Ensure the ground cable is grounded correctly before connecting the power cable.
Disconnect all power supplies before connecting or removing the power cable.
Use the power cable which meets the technical specifications.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
4 Hardware installation
58