Setting The Alarm System - JRC JMA-7133-SA Instruction Manual

>
JMA-7100 Instruction Manual 7.SETTINGS FOR SYSTEM OPERATION
7.2.9

Setting the Alarm System

7.2.9.1 Setting the reset interval (Reset Interval)
This function enables the control of WMRST terminal (on the terminal board
circuit).The reset signal is turned on when operation in a set period of time.
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the Reset
Interval menu.
3) Input the value to be set.
For how to input numeric data on the numeric value input screen, see Section 3.3.4
"Operation on Numeric Value, Latitude / Longitude and Character Input menu".
7.2.9.2 Setting the Trackball Threshold
This function enables the control of WMRST terminal (on the terminal board
circuit).
The reset signal is turned off when trackball is moved, that caused by vibration.If
trackball move distance go over the threshold (dot unit) when reset signal is
turned on.
Procedures
1) Open the Serviceman Menu.
2) Perform the following menu open procedure to open the
Trackball Threshold menu.
3) Input the value to be set.
For how to input numeric data on the numeric value input screen, see Section 3.3.4
"Operation on Numeric Value, Latitude / Longitude and Character Input menu".
2. Installation Menu
→ 6. Alarm System
→
1. Watch Alarm
→
2. Installation Menu
→ 6. Alarm System
→ 1. Watch Alarm
→
7－ 22
>
7.2 SETTINGS
1. Reset Interval
2. Trackball Threshold