Use Route Function; Display Route/Destination Mark (Select Route) - JRC JMA-7133-SA Instruction Manual

3.7

USE ROUTE FUNCTION

In this radar system, a destination mark set by navigation equipment can be
displayed, and a simple route can be created, displayed, loaded and saved. (To use
this function, navigation equipment must be connected to this system)
NOTE:
3.7.1

Display Route/Destination Mark (Select Route)

In this radar system, the following route and destination marks can be displayed.
Route : Route created in the radar system, ECDIS and GPS are displayed.
Destination mark : Destination marks sent from outside navigation equipment are
Procedures
1) Left-click the
radar display.
The Route Menu will appear.
Set the
2)
The following route/destination mark display modes can be selected.
JMA-7100 Instruction Manual
If radar video is poor visibility caused by route function, click the
i
Map button to turn off the Map function. Otherwise, press the
[DATA OFF] key to map displays temporarily off.
The user map function is available between latitudes of 85°N and 85°S.
displayed.
button located at the lower right of the
Route
item.
1. Select Route
Off : Route and destination marks are not displayed.
Internal : Route saved in the system are displayed.
: Destination marks are displayed by using WPT data sent
NMEA
from outside navigation equipment.
: Route created in the ECDIS and GPS are displayed.
ECDIS /GPS
i. To display the mark on the radar display,
○WP
destination mark is displayed only when the Waypoint data is received from
outside by using the NMEA sentence (RMB,BWC,BWR).
ii. When the system display Route which are created in the ECDIS, following items
are not displayed.
• XTL
• Arrival Radius
• ROT
• Turn Radius
• Time Zone
• Sail
3－ 67
> >
3.BASIC OPERATION 3.7 USE ROUTE FUNCTION
i
NMEA
3
ii
select. The