Attaching The Strain-Relief Bracket - Cabletron Systems CSX200 CyberSWITCH Installation Manual

Chapter 4: Installation
Materials Required
The following parts are included in the CSX200-ACCY-KIT.
• Strain-relief bracket (shown in
• Left and right rackmount brackets (shown in
• 8-32 x 1/4-inch, pan-head screws (4)
• 8-32 x 3/8-inch, pan-head screws (4)
Do not use any screws other than those supplied with the CSX200-ACCY-KIT to perform
!
the following procedures.
CAUTION

Attaching the Strain-Relief Bracket

Attach the strain-relief bracket to the front of the CSX200 as follows:
• Locate the strain-relief bracket and four 8-32 x 3/8-inch, pan-head screws provided in the
CSX200-ACCY-KIT.
• Using the four 8-32 x 3/8-inch, pan-head screws, attach the strain-relief bracket to the bottom
of the CSX200 as shown in
4-8
Figure 4-6, on the following page)
Figure
Rackmount
Brackets (2)
Strain-Relief Bracket
Figure 4-5 CSX200 Rackmount Hardware
Figure 4-6, on the following page.
4-7, on the following page)
2012_12
CSX200 Installation Guide