Attaching The Strain Relief Bracket; Installing The Hub - Cabletron Systems MRX Installation Manual

INSTALLATION

3.2 ATTACHING THE STRAIN RELIEF BRACKET

Attach the strain relief bracket to the front of the HUB as follows:
1. Locate the strain relief bracket and four 8-32 x 3/8" screws from
the HUB installation kit.
2. Attach the strain relief bracket to the rear of the HUB as shown
in Figure 3-1.
Figure 3-1. Attaching the Strain Relief

3.3 INSTALLING THE HUB

The HUB can be rack-mounted in a 19-inch rack, wall mounted or
free-standing on any horizontal surface (i.e., shelf or desk, etc.).
Select one of the following subsections and perform the steps that are
applicable for your installation:
3.3.1 Rack Mounting the HUB
3.3.2 Wall Mounting the HUB
3.3.3 Free-Standing Installation
Page 3-2