Chapter 5 Troubleshooting - Cabletron Systems CSX200 CyberSWITCH Installation Manual

5
Troubleshooting
Use this chapter in conjunction with the LANVIEW status monitoring and diagnostic LEDs on the
CSX200 to diagnose power failures, collisions, cable faults and link problems.
the front panel LEDs.
states.
If you are having difficulty installing and configuring the CSX200, take the following steps:
• Review your CSX200 QuickSTART Guide to insure proper installation.
• Check that all cables and connectors have been attached properly.
• Verify that power has been attached.
Power
CPU
Collision
LED
Power (PWR)
Processor (CPU)
CSX200 Installation Guide
Table 5-1, Table 5-2,
Figure 5-1 CSX200 Front Panel LEDs
Table 5-1 CSX200 Hardware LED States
Color
OFF
GREEN
OFF
RED
GREEN (blinking) NORMAL
Table 5-3, Table 5-4, and
Receive Transmit
Link Receive
Link
State
Power Off
Power is on
Power Off
Fault condition detected
Figure 5-1 shows
Table 5-5 describe LED
STS 1
STS 2
Status 1
Status 2
Test
5-1