10Base-T Lan Configuration; Connecting Utp Cables To Ports 1 Through 12 - Cabletron Systems CSX200 CyberSWITCH Installation Manual

10BASE-T LAN Configuration
This section contains the procedures for connecting a UTP segment from the 10BASE-T network
or other devices to the CSX200. Ports 1 through 12 on the CSX200 have RJ45 connectors for UTP
connections.

Connecting UTP Cables to Ports 1 Through 12

Before connecting a segment to the CSX200, check each end of the segment to verify wire
crossover.
To establish a link, you must have an odd number of crossovers (preferably one)
!
between 10BASE-T devices of the same type (i.e., from repeater to repeater or
transceiver to transceiver).
CAUTION
Connect a twisted pair segment to the CSX200 as follows:
1. Ensure that the device at the other end of the segment is connected to the segment and is
powered ON.
2. Refer to Figure
connector on the twisted pair segment into the desired RJ45 port (ports 1 through 12).
CSX200 Installation Guide
3-1. Connect the twisted pair segment to the CSX200 by inserting the RJ45
Figure 3-1 CSX200 Twisted Pair Connection

10BASE-T LAN Configuration

2012_11
3-3