Chapter 4: Installation
CSX-COMP/ENCR
Installing the CSX200
The CSX200 may be installed on a tabletop, on a shelf, or in a 19-inch rack.
Tabletop and Shelf Installations
The following two subsections provide guidelines for installation on a tabletop or shelf.
Before performing tabletop or shelf installation procedures, ensure that the requirements
!
outlined in the section,
CAUTION
To install the CSX200 on a tabletop or shelf, perform the following procedure:
•
Locate the CSX200 within seven feet of its power source with an unrestricted free surface area
as shown in
Figure
•
Locate the six round rubber feet included with your CSX200, and peel the paper backing off
the round rubber feet. Place one rubber foot near each of the four corners of the CSX200, and
evenly space the remaining two near the center.
•
Complete the installation by connecting power as described in
4-6
Standoff Screws
Standoff
Figure 4-3 CSX200-COMP/ENCR Module Installation
Installation Guidelines
4-4, on the following page.
D-Type
Connector Pins
D-Type
Connector
Detail
2204N01
on page 4-1, are met.
Powering the
CSX200 Installation Guide
CSX200.