Cabletron Systems CSX200 CyberSWITCH Installation Manual page 38

Chapter 4: Installation
WPIM
To install a WPIM, follow these instructions:
• Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the
disposable grounding strap package).
• Remove the CSX200 cover (see
• Remove the blank faceplate from the appropriate WPIM slot.
• Orient the WPIM as shown in
the WPIM connector pins on the CSX200.
• Press down firmly on the WPIM until the pins slide all the way into the connector. Ensure that
the WPIM seats flush on the standoffs.
• Secure the WPIM to the three standoffs using the screws supplied.
• Replace the CSX200 cover.
4-4
WPIM Screws
Figure 4-2 Installing WPIMs
Removing the CSX200 Cover
Figure 4-2, above, and carefully insert the WPIM connector into
WPIM
Connector
WPIM
Connector Pins
Standoffs
on page 4-2).
CSX200 Installation Guide