Command 0Xa2 Completion - Magtek DynaPro Mini Programmer's Manual

3 - Command Set
Data><len><val>
Only)
Data><len><val>
in the clear*/
data */
multiple of 8 bytes>
TLV data container F5 contains Encrypted PIN data using ISO Format 0 in nested data object 99, plus
supporting information to decrypt it. The host should use the current PIN DUKPT working key specified
in the supporting information.
The device calculates the CBC-MAC using the Message Authentication, request or both ways variant of
the current MSR DUKPT working key used in the relevant transaction.

3.6.3.3 Command 0xA2 Completion

When this command completes (card read OK, transaction finished, ICC problems, command cancelled,
cardholder cancels, or timeout):
1) The device clears all sensitive data buffers and sends a Report 0x22 - Card Status Report to the
host, and will continue to show
2) If the report indicates the cardholder has pressed the
transaction.
3) If the Card Status and Operation Status are both OK, the host should send a request to get the EMV
card data with Command 0xAB - Request EMV Transaction Data (MAC-MSR). It may call this
multiple times if necessary.
4) The host should wait for as long as the solution design requires
5) The host should send the device Command 0x02 - End Session to clear
display and make the device ready for the next transaction.
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
DFDF38 <EncT2status><len><val>
DFDF39 <EncT2data><len><val>
DFDF3A <EncT3status><len><val>
DFDF3B <EncT3data><len><val>
DFDF3C <Encrypted Magneprint
DFDF3D <MS2.0 Status><len><val> (MS2.0
DFDF43 <Magneprint Status
DFDF50(MSR KSN Data)<len><val> /*sent
DFDF51(MSR EncryptionType)<len><val>
F5<len>/* container tag for encrypted PIN
99(Encrypted PIN DATA)<len><val>
DFDF41(PIN KSN Data)<len><val>
DFDF42(PIN EncryptionType)<len><val>
<Padding to force DFDF59 plus padding to be a
on the display.
THANK YOU
Page 78 of 128 (D99875629-43)
Cancel button, the host should abort the
THANK YOU
THANK YOU
to show on the display.
from the