Command 0X32 - Get Bin Whitelist Table - Non Financial Format; Command 0X58 - Request Device Certificate; Command 0Xff - Device Reset - Magtek DynaPro Mini Programmer's Manual

3 - Command Set

3.4.28 Command 0x32 - Get BIN Whitelist Table - Non Financial Format

This command will cause the device to send the current contents of the BIN whitelist for non-financial
cards to the host in the following format:
Table 3-44 - Usage Table for Command 0x32 (Get mode)
Bit 7
Byte 0 0x32
Byte 1 Number of bytes to follow (36 for the 6 slots)
Byte 2..7 Data on BIN Table Slot 1
Byte 8..13 Data on BIN Table Slot 2
Byte 14..19 Data on BIN Table Slot 3
Byte 20..25 Data on BIN Table Slot 4
Byte 26..31 Data on BIN Table Slot 5
Byte 32..37 Data on BIN Table Slot 6
If an error occurs, the device will terminate the command and report the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Appendix C Status and Message Table, Table
3-76.

3.4.29 Command 0x58 - Request Device Certificate

This command directs the device to send the device certificate to the host.
If an error occurs, the device will terminate the command and report the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Appendix C Status and Message Table, Table
3-76.
If no error occurs, the device will send Report 0x29 - Send Big Block Data to Host to the host.
Table 3-45 - Usage Table for Command 0x58 (For Device Cert)
Bit 7
Byte 0 0x58
Byte 1 0x02
Byte 2 0x01
Byte 3..6 0x00

3.4.30 Command 0xFF - Device Reset

This command directs the device to perform a restart.
Table 3-46 - Usage Table for Command 0xFF
Bit 7
Byte 0 0xFF
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
6 5
6 5 4
6 5 4
Page 58 of 128 (D99875629-43)
4 3 2
3 2
3 2
1 0
1 0
1 0