Magtek DynaPro Mini Programmer's Manual page 31

3 - Command Set
If an error occurs, the device will terminate the command and report the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Appendix C Status and Message Table, Table
3-76.
When this command completes (card swiped OK, cardholder or operator cancelled, or timeout), the
device will send Report 0x22 - Card Status Report to the host. If the Card and Operation Status are
both OK, the host should then send Command 0x0A - Request MSR Data to get the card data.
For an example of using this command, see Appendix A.1 How to Get MSR/PIN Data from the Device
for a Bank Simulation.
Table 3-3 - Usage Table for Command 0x03
Bit 7
Byte 0 0x03
Byte 1 Wait time in seconds, (1 - 255; 0 = infinite wait time)
Card Message ID to display:
0 = Swipe Card / Idle alternating
1 = Swipe Card
Byte 2
2 = Please Swipe Card
3 = Please Swipe Card Again
4 = Chip Error, Use Mag Stripe
Tones:
0 = No sound
Byte 3
1 = One beep
2 = Two beeps
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
Figure 3-2 - DynaPro Mini Initial Swipe Prompt
6 5
Page 31 of 128 (D99875629-43)
4 3 2 1 0