Appendix I Bluetooth Le Module Control Data (Bluetooth Le Only); Bluetooth Le Module Configuration Properties; Get Property Command; Set Property Command - Magtek DynaPro Mini Programmer's Manual

Appendix I - Bluetooth LE Module Control Data (Bluetooth LE Only)

Appendix I Bluetooth LE Module Control Data (Bluetooth LE Only)

This section defines control messages that can be sent to the device's Bluetooth LE module. The general
format for control messages is as follows, and the specific commands can be found in subsequent
sections:
Byte 0 Message type
0 = Request
1 = Response
2 = Notification
Request message type
Byte 1 Command identifier
Byte 2..n Command request data
Response message type
Byte 1 Response Code
0 (success)
1 (failure)
2 (bad parameters)
Byte 2..n Command response data
Notification message type
Byte 1 Notification identifier
Byte 2..n Notification data
I.1

Bluetooth LE Module Configuration Properties

I.1.1

Get Property Command

Request message
Byte 0 0 (Request message type)
Byte 1 0 (Get property command identifier)
Byte 2 Property identifier
Response message
Byte 0 1 (Response message type)
Byte 1 Response code
Byte 2..n Property value
I.1.2

Set Property Command

Request message
Byte 0 0 (Request message type)
Byte 1 1 (Set property command identifier)
Byte 2 Property identifier
Byte 3..n Property value
Response message
Byte 0 1 (Response message type)
Byte 1 Response code
I.1.3

Software ID Property

Property ID: 0x00
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
Page 119 of 128 (D99875629-43)