Command 0X1E - Set Ipod Accessory Protocol (Iap) Info (30-Pin Only); Command 0X1E - Get Ipod Accessory Protocol (Iap) Info (30-Pin Only); Command 0X30 - Set / Get Ksn - Magtek DynaPro Mini Programmer's Manual

3 - Command Set
Table 3-38 - Usage Table for Command 0x1D
Bit 7
Byte 0 0x1D (command identifier)
Byte 1 Control data length (defined in Appendix I)
Byte 2 to
(2+control Control data (defined in Appendix I)
data length-1)
Byte (2 +
control data Padding. Set all bytes to zero.
length) to 63

3.4.24 Command 0x1E - Set iPod Accessory Protocol (iAP) Info (30-pin Only)

When the host calls this command in Set mode, it sets iPod Application Protocol (iAP) related data in the
device.
Table 3-39 - Usage Table for Command 0x1E (Set mode)
Bit 7
Byte 0 0x1E (command identifier)
0 = Set Bundle Seed ID (10 bytes)
Byte 1
1 = Set reverse DNS (variable, up to 50 bytes)
Byte 2 Data Length
Byte 3..63 Data

3.4.25 Command 0x1E - Get iPod Accessory Protocol (iAP) Info (30-pin Only)

When the host calls this command in Get mode, it retrieves the current device iPod Application Protocol
(iAP) protocol Bundle Seed ID and reverse DNS in the following format:
Table 3-40 - Usage Table for Command 0x1E (Get mode)
Bit 7
Byte 0 0x1E (command identifier)
Byte 1 Length of Bundle Seed ID, normally 0x0A (<=0x0A)
Byte 2..11 Bundle Seed ID, high bytes padded with 0x00 if length is less than 0x0A
Byte 12 Reverse DNS Length (<= 0x32)
Byte 13..63 Reverse DNS, high bytes padded with 0x00 if length is less than 0x32

3.4.26 Command 0x30 - Set / Get KSN

When called in Set mode, this command directs the device to generate a KSN data for transmission to a
host.
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
6 5 4
6 5 4
6 5 4
Page 55 of 128 (D99875629-43)
3 2 1
3 2 1
3 2 1
0
0
0