Reading All Emv Tags - Magtek DynaPro Mini Programmer's Manual

3 - Command Set

3.6.2.1 Reading All EMV Tags

To read all EMV tags stored on the device, the host should send the following command:
Table 3-63 - Usage Table for Command 0xA1 (Set form to Read All Tags)
Bit 7
Byte 0 0xA1
Specifies which EMV or Contactless tag group to read:
00 = EMV/Contactless
Terminal tag group
Byte 1
10 = EMV/Contactless
Application tag group
Byte 2 0x0F=Read all EMV terminal or payment brand tags
Database Selector:
Byte 3
00 = Contact L2 EMV Tags
Byte 4..8 Reserved
If an error occurs, the device will terminate the command and report the error in ACKSTS of Command
0x01 - Response ACK. For a full list of error codes, see Appendix C Status and Message Table, Table
3-76.
If no error occurs, the device will send Command 0x01 - Response ACK, then send Report 0x29 - Send
Big Block Data to Host with the EMV tags and requested data.
DynaPro Mini| PIN Encryption Device | Programmer's Manual (Commands)
6 5 4
If bits 6 and 7 are set to EMV/Contactless Application, bits
0-5 specify which application slot to read.
Number of supported slots:
Contact: 0..9 (Contact Chip Card Only)
Page 70 of 128 (D99875629-43)
3 2 1 0