Responsibility; Ce Marking; Safety Instructions; General Information - BONFIGLIOLI DGM MPM Technical Manual

General information

1.7 Responsibility

As a basic principle, electronic devices are not fail-safe.
The operator and/or the contractor setting up the machine
or system is responsible for ensuring that the drive
switches to a safe state if the device fails.
The "Electrical equipment of machines" section in DIN EN
60204-1; VDE 0113-1, "Safety of machinery" describes the
safety requirements for electrical control units. These are
provided for the safety of people and machines and must
be observed in order to retain the functional capability of
the machine or system.
An emergency stop feature does not have to result in the
voltage supply to the drive being switched off. To avoid
dangerous situations, it may be useful for individual drives
to remain operational or for specific safety procedures to
be initiated.
The effectiveness of emergency stop measures is
evaluated by means of a risk assessment for the machine
or system and its electrical equipment and is determined
by selecting a circuit category according to DIN EN 13849
"Safety of machinery – Safety-related parts of control
systems".

1.8 CE marking

Bonfiglioli Riduttori S.p.A. hereby declares that the drive
controller described in this document complies with the
basic requirements and other relevant conditions of the
directives listed below.
◼
Directive 2014/30/EU
(on the approximation of the laws of the Member
States relating to electromagnetic compatibility
(EMC)).
◼
Directive 2014/35/EU
(on the harmonisation of the laws of the Member
States relating to the making available on the market
of electrical equipment designed for use within certain
voltage limits – in short: Low Voltage Directive).
◼
Directive 2011/65/EU
(Restriction of the use of certain hazardous
substances in electrical and electronic equipment, in
short: RoHS Directive)
◼
Directive 2014/53/EU
(relating to the making available on the market of
radio equipment and repealing Directive 1999/5/EC)
8

1.9 Safety instructions

The following warnings, precautionary measures and
information are provided for your safety and serve to
prevent damage to the drive controller and the
components connected to it.
This chapter contains warnings and information that are
universally applicable when handling drive controllers.
They are split into General information, Transport &
storage and Disassembly & disposal.
Specific warnings and comments that apply to specific
activities can be found at the start of the appropriate
chapters and are repeated or added to at various critical
points in these chapters.
Please read this information carefully as it is provided for
your personal safety and will also prolong the life of the
drive controller and connected devices.
1.9.1
◼
◼
Operating manual for DGM Modular | DOC02389740-0006 | 2021-07 | V1.70 EN
General information
IMPORTANT INFORMATION
Carefully read this operating manual and the
warning signs affixed to the drive controller before
installation and commissioning. Make sure that all
warning signs on the drive controller are legible;
replace any missing or damaged signs.
They contain important information on the
installation and operation of the drive controller.
Note the information in the "Important information"
chapter.
Bonfiglioli Riduttori S.p.A. assumes no liability for
damages arising from the non-observance of this
operating manual.
This operating manual is an integral part of the
product. It applies exclusively to the drive
controller from Bonfiglioli Riduttori S.p.A..
Keep the operating manual close to the drive
controller so it is easily accessible to all users.
The drive controller can only be operated safely if
the required environmental conditions listed in the
"Suitable environmental conditions" chapter are
met.