Labels On The Drive Controller; Qualified Staff; Proper Use - BONFIGLIOLI DGM MPM Technical Manual

1.4 Labels on the drive controller

Fig. 4: Labels on the drive controller
Signs and labels are affixed to the drive controller. These may not be altered or removed.
Symbol Meaning
Danger due to electrical shock and
discharge
Danger due to electrical shock and
discharge. Wait two minutes (discharge
time of the capacitors) after shut-down

1.5 Qualified staff

In the context of this operating manual, qualified staff
refers to electronics specialists who are familiar with the
installation, assembly, commissioning and operation of the
drive controller and the dangers involved, and whose
specialist training and knowledge of relevant standards
and regulations provide them with the necessary abilities.

1.6 Proper use

If the device is installed in a machine, drive controllers
may not be commissioned (i.e. intended operation may not
begin) until it has been determined that the machine
complies with the regulations of EC Directive 2006/42/EC
(Machinery Directive); DIN EN 60204-1; VDE 0113-1 must
be observed.
Commissioning (i.e. beginning intended operation) is only
permitted if the EMC Directive (2014/30/EU) is complied
with.
Operating manual for DGM Modular | DOC02389740-0006 | 2021-07 | V1.70 EN
Symbol Meaning
Additional earth connection
Observe and read operating manual
The harmonised standards of DIN EN 50178; VDE 0160
must be applied for this drive controller along with DIN EN
61439-1/DIN EN 61439-2; VDE 0660-600.
This drive controller may not be operated in areas where
there is a danger of explosion!
Repairs may only be performed by authorised repair
bodies.
Independent and unauthorised intervention may result in
death, injury or property damage. The warranty provided
by Bonfiglioli will be invalidated in such cases.
IMPORTANT INFORMATION
◼
External mechanical loads on the housing are not
permitted!
◼
Using drive controllers in equipment that is not
fixed is considered as an exceptional
environmental condition and is only permitted if
allowed by the standards and guidelines applicable
on site.
7