Live Page; Overview - Arturia TAE ORIGIN User Manual

Table of Contents

[Rate 1 / 2]: These knobs set the rate of the internal LFO for phaser 1 and 2.

[Depth 1 / 2]: These knobs set the modulation depth for phaser 1 and 2

[Feedback 1/2]: These knobs set the amount of feedback for phaser 1 and 2

[Dry / Wet]: This virtual knob controls the mix of the processed and original signal. This

knob is only active if the program mixer is configured in a serial setting. In this case you

can also control this parameter using the [Return] knobs in the [Effects] section on

Origin's front panel. If the mixer is configured in parallel setting, the [dry/wet] knob is

grayed out (always 100 % wet).

[Stereo]: This knob sets the stereo width of the phaser effect

[Shape 1 / 2]: This switch controls whether the internal LFO is based on a sine wave or a

low frequency noise signal.

[Sync]: If set to ON the delay time of both channels synchronizes to multiples of either

the internal clock or MIDI clock (depending on the SYSTEM SETTINGS tab of the HOME

page, see section 9.1 of the manual for more information). If this setting is set to OFF,

the delay times can be set independently.

[Dual mode]: If this switch is set to ON, the two phasers are configured in a serial

connection (i.e. the output of phaser 1 is fed into phaser 2). When set to OFF, both

phasers work in parallel.

8.7 Live page

8.7.1

The Live page is the place where you can set macro-level edits for each area of the analog section,

as well as configure the joystick and view the assignment of the rotary encoders placed on each side

of the LCD panel. The "Live" tab within the Live page can be particularly important while jamming,

but can also be a boon when manipulating a program during sequencing or recording.

The Live page also allows access to tabs that enable you to set the routing of MIDI controllers to

various destinations within the Origin, as well as a tab for setting the joystick layout for each of

three modes of operation.

When you look at the Live page display area, you can see a series of tabs along the top of the LCD

screen. These tabs are selected by the corresponding button along the top of the LCD screen. These

include:

The [Live] tab (which is the default for the Live page)

The Oscillator Macro Edit [OSC] tab

ARTURIA – ORIGIN – USER'S MANUAL

The dual phaser

Table of Contents