Serial] Routing - Arturia TAE ORIGIN User Manual

- [Pre/Post]: If this switch is set to [pre], the FX 1, 2 and 3 knobs are configured pre-fader.
This means that the volume slider has no effect on the amount of signal sent to the
effects. If set to [post], the FX 1, 2 and 3 knobs are configured post-fader. This means
that adjusting the volume of the VCA also adjust the amount of signal sent to the effects.
- [Ret 1, 2, 3]: (returns) These knobs set the amount of effect signal sent to Origin's main
outputs for each of the three available effects.
8.3.2.2

[Serial] routing

In series mode, the outputs of all VCAs are mixed to one stereo signal. This signal is then sent to FX
1. The output of FX 1 is sent to FX 2, the output of FX 2 is sent to FX 3. The output of FX 3 is sent to
the [Main] output. In this mode, the [FX 1, 2, 3] knobs and the [pre/post] switch are grayed out
(since they have no effect) and the [Ret] knobs change to [D/W] (see below).
- [Pan]: These knobs control the panoramic placement of the VCA. This knob controls the
same parameter as the pan knob found on the corresponding VCA module in the [Edit]
page.
- The VCA volume slider at the bottom sets the volume of the corresponding VCA. This knob
controls the same parameter as the volume slider found on the corresponding VCA module
in the [Edit] page. This knob can also be controlled using the corresponding hardware
knobs found on the [Mixer] section of Origin's front panel.
- [D/W]: (dry/wet) these knobs control the balance between unprocessed (dry) signal and
signal processed by the corresponding effect (wet). When turned fully left, you hear no
effect, when turn fully right you only hear the processed signal. These knobs control the
same parameter as the [Dry/wet] knobs on the [FX] page. You can also use the hardware
knobs found on the [Effects] section of Origin's front panel to control this parameter.
ARTURIA – ORIGIN – USER'S MANUAL
The Parallel mode
59