Sequencer] Section; Rear Panel - Arturia TAE ORIGIN User Manual

Table of Contents

The [Volume 1...3] knobs control the return volume or dry/wet balance of the three

effects. (For more details, refer to chapter 7.3.2)

The [Edit 1...3] buttons jump directly to the "Fx1...3" slot on the [Effect] page.

The [On/Off] mute or bypass the selected effect. (For more details refer to chapter

7.3.2)

4.1.9

[Sequencer] section

In this panel, you can find all of the real-time controls concerning the sequencer.

The [Play/Stop] button toggles the step sequencer on or off. When set to on, the

step sequencer starts running when a note is pressed and stops when the last note is

released.

The [Hold] button toggles hold on or off. When hold is on, are active and new notes

are held until the hold button is switched off again.

NOTE: You can also use this function when the sequencer is not playing.

The [Seq1...3 Act] buttons activate or deactivate sub-sequence 1...3.

The [Edit> Seq1... Seq3, Pattern] button selects the corresponding sequence for

editing or, when [pattern] is selected, activates pattern selection mode.

The [Assign] button opens the "assign" pop-up of the selected sub-sequence.

The [Hold] button locks the currently playing sequencer step. The sequencer is

stopped and keeps sending its current modulation values until the lock button is

pressed again.

The [Trig] button activates the key trigger on the current step of the selected sub-

sequence.

The [Accent] button triggers the accent envelope on the current step of the

selected sub-sequence.

The [Slide] button activates the slide function on the current step of the selected

sub-sequence. It changes smoothly from the current value to the value of the next

step in the sequence.

The [1...16] encoders set the value of step 1...16 (or 17...32).

The [1...16] buttons have two functions: in [Edit Seq1...3], they select step 1...16 (or

17...32). In [Pattern] selection mode, these buttons select a pattern preset 1...16.

On this panel, you can find all the power, audio and MIDI connections.

From right to left you can see:

The [Power] button allows to turns the power on/off.

[DC IN] Connection for the included AC/DC 6.5V power adaptor.

[USB]: Input for connection with a computer. It can be used for MIDI IN and OUT

communications or for data transfer (e.g. preset dump, software updates...)

ARTURIA – ORIGIN – USER'S MANUAL

Table of Contents