The [Global] Settings Of The Sequencer - Arturia TAE ORIGIN User Manual

Table of Contents

The [Accent] settings bring an additional modulation to the selected step using a simple

"Attack"/"Decay" (AR) envelope. The accent envelope can be applied to any modulation

input. It has three parameters:

The [A] knob sets the Attack time of the accent envelope

The [D] knob sets Decay time of the accent envelope

The [Level] potentiometer sets the modulation amount of the accent in order to affect

parameters such as the low pass VCF Filter.

The [Slide] knob sets the portamento time between the selected step and the following

step.

The [Length] knob sets the length of the pulses for the gates (this setting affects all the

steps of the selected sub-sequence).

8.5.10.4 The [Global] settings of the sequencer

The [Global] settings include:

The memory location of the current pattern:

8 Factory Banks named from [A] to [H], and 8 user Banks named from [I] to [P]

Each bank contains 16 patterns [1...16]

The number of steps within the current pattern from [1] to [32]

[Sync On/Off] allows synchronizing the sequencer rate to the internal tempo or the

external MIDI clock.

The [Rate] sets the subdivision of the steps length from the internal or MIDI tempo.

[Modes] allows to select the playing mode of the sequence:

[FWD] Playing the sequence forward

[BWD]: Playing the sequence backward

[FWD/ BWD]: Playing the sequence forward and backward

ARTURIA – ORIGIN – USER'S MANUAL

Set the accent's modulation amount

The modulation settings of the sub-sequence

Table of Contents