Common Section - Arturia TAE ORIGIN User Manual

Set the waveforms and the frequencies of the Program LFO using the [▲/▼] buttons or the jog
dial.
Set the input connections:
[Trig input]: This input allows you to trigger the delay period of the LFO. When a trigger signal
is received here, the delay period starts.
[AM input]: This input modulates the amplitude of the LFO. You can for example connect it to
the mod wheel fade in and out the LFO action manually.
[FM input]: This input modulates the frequency of the LFO. You can for example connect it to a
Galaxy output to create very complex modulation signals.
[PWM input]: This input modulates the pulse width (or symmetry) of the LFO. This input is only
active when the square of triangle waveform is selected.
Set the output connections:
[Output]: This is the output of the LFO, you can connect it to the modules you want to be
modulated by the LFO.
8.3.6

Common section

The common area is located on the right side of the display, and contains the same information
regardless of which tab is selected within the Program page. Below is a listing and general
description of its parameters and value ranges.
To go on the common area interface, press on the [▲/▼] buttons and press the jog dial (the
common area is highlighted in red) to enter in edition. To go out of this area, press again on the jog
dial or on the [Enter] button.
ARTURIA – ORIGIN – USER'S MANUAL
The Program LFO settings
The Program LFOs connections
65