Configure Network Interface Using A Vt100 Terminal; Using Telnet; Interpreting Alarms And Status Messages - ADTRAN Smart 16e Shelf User Manual

Hide thumbs Also See for Smart 16e Shelf:
Table of Contents

Advertisement

Configure Network Interface Using a VT100 Terminal

Configure Network Interface Using a VT100 Terminal
To set up the Smart 16e Shelf to accept SLIP, async PPP, or Ethernet communication from a network
manager, perform the following steps:
1. Connect the terminal to the Smart 16e controller EIA-232 port. The terminal settings should match the
Smart 16e controller baud rate setting (i.e., 9600 bps, 8 data bits, no parity, and 1 stop bit).
2. Apply power to the Smart 16e controller card. Press Enter until the Login screen appears on the
terminal screen.
3. Go to the
E
THERNET
4. Configure the following Smart 16e network interface settings: IP address, Subnet Mask, Gateway IP
address (if required), Trap Host IP address, GET community name, SET community name, and SNMP
Trap community name.
4.

USING TELNET

The Smart 16e Shelf supports Telnet access, allowing remote access to the Smart 16e Shelf menu interface
by the network manager.
To access the Smart 16e Shelf menu interface, establish a Telnet session using the Smart 16e Shelf IP
address to open a device session. The Smart 16e Shelf's Main menu will display. Configure or monitor the
Smart 16e Shelf devices as if they were locally connected to the shelf with a VT100 terminal. Close the
Telnet application according to the network manager's instructions.
5.

INTERPRETING ALARMS AND STATUS MESSAGES

The four character display on the controller card front panel (Figure 25 on page 49) provides status
information about the Smart16e Shelf and the data communication cards that are installed in the shelf. If
no alarm conditions exists,
alternate between
ALM
display the source of the alarm. Table 4 on page 49 lists the alarm messages.
The
STATUS
LED provides a status of the Smart 16e controller card. Table 5 on page 50 lists the LED
states and their meanings.
48
C
menu.
ONFIGURATION
SM16
appears on the display. If an alarm condition exists, the display will
and
SM16
. Pressing the
© 2004 ADTRAN, Inc.
MODE
button on the front of the controller card will
Smart 16e Shelf User Manual
64202023L5-1B

Advertisement

Table of Contents
loading

This manual is also suitable for:

4202023l54202023l64202023l74202023l8

Table of Contents