Fx30S Factory Configuration; Esim Support; Auto-Sim; Sim Auto Switch - Sierra Wireless Octave FX30S User Manual

E: FX30S Factory Configuration

eSIM support

Some FX30S variants (such as FX30S Cat-1 WP7607-1) support eSIM. The external 2FF
SIM slot is the preferred slot, but the internal eSIM will be used if no external SIM is
inserted. You can change the slot using the AT command AT!UIMS or the Legato
command cm sim select.
Note: If SIM AUTO SWITCH is enabled, the !UIMS setting is updated to reflect the preferred slot.
See

SIM AUTO SWITCH

AUTO-SIM

The AUTO-SIM feature applies to Cat-1 and Cat-M variants, and is enabled by default.
This feature reboots the device and loads the carrier configuration (PRI) that corresponds
to the SIM. For example, if the external slot is enabled, and a Sierra SIM is inserted, the
Sierra carrier PRI will be loaded. By default, if a carrier PRI does not exist (the SIM's
carrier does not match a PRI loaded on the radio module), the generic carrier PRI is
loaded. Note that the AUTO-SIM feature is not persistent over a firmware update;
however, you can re-enable it by using the AT command AT!IMPREF="AUTO-SIM".
SIM AUTO SWITCH
The SIM AUTO SWITCH feature applies to Cat-1 (R10.1.1 and later) and Cat-M (R11 and
later) variants. This is a customization that allows a user to select the preferred slot. By
default, the external slot is the preferred slot. You can change the preferred slot by
executing the AT command AT!CUSTOM="UIMAUTOSWITCH".
Note: This command requires level 2 unlocking. See the
Command Reference
Rev. 5 September 2020
below.
for more information.
81
WP8548/WP75xx/WP76xx/WP77xx AT
E
41110485