Step 3-Connect The Antennas - Sierra Wireless Octave FX30S User Manual

4. The mounting holes in the adapter bar match the existing mounting holes for the
For DC installations (with a fixed "system" ground reference), Sierra Wireless
recommends always grounding the FX30S chassis to this system ground reference.
To ensure a good grounding reference, attach the FX30S to a grounded metallic surface.
Step 3—Connect the Antennas
Warning:
least 8 inches (20 cm) away from the operator.
The FX30S has two SMA female antenna connectors:
•
•
For regulatory requirements concerning antennas, see
page 57.
Note: The antenna should not exceed the maximum gain specified in
more complex installations (such as those requiring long lengths of cable and/or multiple connec-
tions), you must follow the maximum dBi gain guidelines specified by the radio communications
regulations of the Federal Communications Commission (FCC), Industry Canada, or your country's
regulatory body.
Rev. 5 September 2020
Mounting holes
Mounting bracket
Figure 2-11: Attaching the compatibility bar
Fastrack Supreme or Fastrack Xtend.
This gateway is not intended for use close to the human body. Antennas should be at
Cellular antenna connector
GNSS antenna connector
GNSS bias supports 3.15 V antennas
Raised knobs
19
Installation and Startup
Compatibility bar
Raised flaps
Maximum Antenna Gain
RF Exposure on page 57. In
on
41110485