Using The Fx30S As A Usb Modem - Sierra Wireless Octave FX30S User Manual

B: Using the FX30S as a USB Modem
The following instructions provide examples based on Telus service. Substitute the name
of your mobile network operator (MNO). Key values and parameters are bolded for
emphasis in the examples.
For detailed information about the AT commands used, refer to WP8548/WP75xx/
WP76xx/WP77xx AT Command Reference (document number 4118047) available at
source.sierrawireless.com.
To use the FX30S as a USB modem:
1. Ensure that your computer is set up to issue AT commands to the FX30S. (See
for Windows
2. Connect the radio to the network:
a. If you have not already done so, install the SIM card. (See
b. Set the MNO's APN using the AT+CGDCONT command. (Most MNOs use Profile
c. Check that the profile is correctly set:
d. Check that the radio is attached and registered on the network.
3. Activate the PDP context:
a. Use the Profile number prepared in steps 2b and 2c above.
b. Check the profile is active:
Rev. 5 September 2020
on page 34.)
Card and Optional IoT Expansion Card
number 1. To confirm, check with your MNO.)
AT+CGDCONT=1,"IPV4V6","isp.telus.com"
AT+CGDCONT?
+CGDCONT: 1,"IPV4V6","isp.telus.com","0.0.0.0",0,0
AT!GSTATUS?
!GSTATUS:
Current Time: 5699
Bootup Time: 0
System mode: WCDMA
WCDMA band: WCDMA 1900
WCDMA channel: 662
GMM (PS) state:REGISTERED
MM (CS) state: IDLE
WCDMA L1 State:L1M_PCH_SLEEP
RRC State: DISCONNECTED
(1108 30236)
RxM RSSI C0: -80
RxM RSSI C1: -106
IMS Reg State: UNKNOWN
IMS Srv State: UNKNOWN SMS,UNKNOWN VoIP
OK
AT!SCACT=1,1
AT!SCACT?
!SCACT: 1,1
64
Step 1—Insert the SIM
on page 12.)
Temperature: 31|
Mode: ONLINE
PS state:
NORMAL SERVICE
NORMAL SERVICE
LAC: 2B5D (11101)
UTRAN Cell ID:
RxD RSSI C0: -106
RxD RSSI C1: -106
IMS Mode: Not Support
Setup
Attached
0454 761C
41110485
B