Step 5-Connect The Power And I/O; Fusing; Power And I/O Connections - Sierra Wireless Octave FX30S User Manual

Sierra Wireless FX30S User Guide
Step 5—Connect the Power and I/O
The Sierra Wireless FX30S comes with a 1.5 meter (about 5 ft.) DC power cable. For
more information on the DC power cable, see
AC adapter.
Warning:
thoroughly trained in safe electrical wiring procedures.
The FX30S supports an operating voltage of 4.75–32 V.

Fusing

The Sierra Wireless DC power cable has a 3 A fuse installed in the cable. If that cable is
used, no additional fusing is required.

Power and I/O Connections

Table 2-1
O Configuration
Figure 2-14: FX30S Power Connector
Table 2-1: Power Connector Pin and DC Cable Wires
Pin
1
2
Rev. 5 September 2020
Electrical installations are potentially dangerous and should be performed by personnel
describes the functions for the pins on the FX30S power connector. See also
on page 26.
6 5 4
3 2 1
Function Associated
DC Cable
Wire Color
Power Red
Ground Black
page 60. You can also purchase an optional
Description
(20 AWG + Fuse)
Main power supply for device
Fuse: Slow-blow 3 A, 250 V (5 × 20 mm)
Note: If you want to turn the FX30S on/off using a control line,
Sierra Wireless strongly recommends that you connect the on/
off line to Pin 3 and apply continuous power on Pin 1.
(20 AWG)
Main device ground
22
I/
41110485