Horizontal Termination - Jøtul GF 400 DV IPI Sebago Installation And Operation Instructions Manual

139548-N GF 400 DV IPI 7/21

Horizontal Termination

Any horizontal termination must fall within the shaded

portion of the vent window matrix shown in fig. 9.
For Snorkel Terminations, see page 13.
Any horizontal termination except a snorkel termina-

tion, must include:
1) Minimum rise of 24 in.
2) Minimum horizontal run of 12 in.
3) Vertical run no more than 35 ft.
4) Horizontal run no more than 27 ft.
5) No more than four 45° or two 90° Elbows. The run
must be reduced by 5 feet for each additional elbow.
The horizontal termination cap must maintain a 3"

clearance to any overhead combustible projections
2 1/2" or less. It must also maintain 12" clearance from
projections exceeding 2 1/2". See fig. 19.
Wall Cut-out Opening: A minimum 10" X 10" (250 mm

x 250 mm) square hole is required for proper pipe
clearances through a combustible wall.
12
24 in.
Min. Rise
(305 mm)
Figure 14.
Minimum vent required for horizontal termination.
12 in.
(305mm)
57 in.
(1448mm)