Jøtul GF 400 DV IPI Sebago Installation And Operation Instructions Manual page 29

139548-N GF 400 DV IPI 7/21
Control Functions
Pilot Mode
Set the stove switch to CPI mode for Proflame 2
remote control. The IPI/CPI functionality will be
controlled by the remote transmitter.
Burner Control
Set the stove burner switch to ON for Proflame 2
remote control.
OFF - Turns off both remote and manual burner
functionality. Switch to OFF when the stove will not be
used for an extended period of time.
Remote Transmitter
The Transmitter features a simple button layout and
informative display screen. See figs. 51-52.
LCD DISPLAY - graphically indicates temperature
settings and status of the Thermostat, Burner, Fan, and
Accent Lamp.
ON / OFF Key - controls Burner, Fan, and Lamp functions.
THERMOSTAT Key - Used to set either Manual or
Thermostatic Control and index through thermostatic
functions.
UP / DOWN Arrow Key - Selects thermostat
temperature range, fan speed, and flame height.
MODE Key - used to select the component to be
controlled: CPI/IPI, Burner, Fan, and Accent Lamp.
The Wall Mount Bracket can be used for convenient
Transmitter storage.
Thermostat
ON / OFF / SMART
Temperature Level State
Figure 48. Remote transmitter display data.
29
Transmission
Set Point
Burner
Modulation
Fan Modulation
Initializing the System
1. Press the Controls Access Door to release its magnetic
catch and swing the panel down.
Switch the Burner to OFF. See fig. 40, pg. 25.
2. Install three AAA batteries into the Transmitter.
3. Press the black (or red) button on the right front corner
of the IFC board, just behind the stove switch plate.
The board will "beep" three times and a yellow LED
indicates a 10-second synchronization time limit.
4. Within the 10-second time frame, push the ON button
on the Transmitter. The IFC will "beep" four times to
indicate that it has acknowledged the transmitter
command and sets to the particular code of that
Transmitter.
5. To return to full Manual functionality, hold the black
initialization button down until it "beeps".
6. After initialization, the burner switch must be placed
in the ON position and Pilot Mode switch placed in CPI.
The remote can then be used to control the burner.
Figure 47. Remote transmitter function keys.
OFF
ON
SMART
MAX
MAX
Blue LCD Screen
ON/OFF Key
THERMOSTAT Key
UP/DOWN Key
MODE Key
Child Safety Lock-out
Low Battery Alarm
°F
°C
Room
Temperature
CPI Mode
AUX
(Not Applicable)
Split Valve
(Not Applicable)
Lamp - ON / OFF