Table of Contents
Advertisement
.
3.3 Channel-zero Encoding
Sometimes you need to get a remote view of many channels in real time from web browser or CMS (Client
Management System) software, in order to decrease the bandwidth requirement without affecting the image
quality, channel-zero encoding is supported as an option for you.
Steps:
1. Enter the Live View Settings interface.
Menu> Configuration> Live View
2. Select the Channel-Zero Encoding tab.
3. Check the checkbox after Enable Channel-Zero Encoding.
4. Configure the Frame Rate, Max. Bitrate Mode and Max. Bitrate.
5. Click the Apply button to activate the settings.
After you set the Channel-Zero encoding, you can get a view in the remote client or web browser of 16
channels in one screen.
3.4 Adjusting Live View Settings
1. Enter the Live View Settings interface.
Menu> Configuration> Live View
The settings available in this menu include:
•
Video Output Interface: Designates the output to configure the settings for. Outputs include
HDMI/VGA and CVBS (depends on the model).
•
Live View Mode: Designates the display mode to be used for Live View.
•
Dwell Time: The time in seconds to dwell between switching of channels when enabling auto-switch
in Live View.
•
Enable Audio Output: Enables/disables audio output for the selected camera in the live view mode.
•
Event Output: Designates the output to show event video; if available, you can select a different
video output interface from the Video Output Interface when an event occurs.
•
Full Screen Monitoring Dwell Time: The time in seconds to show alarm event screen.
2. Set the camera order.
1) Select View tab.
2) Click a window to select it, and then double-click a camera name in the camera list you would like to
display. Setting an 'X' means the window will not display any camera.
3) You can also click
channels. Click
4)
Click the Apply button.
to start live view of all channels in order and click
or
to go to the previous or next page.
25
to stop live view of all
Advertisement
Table of Contents
