Using The Wizard For Basic Configuration - Nuvico HDoCS DT_E/P Instruction Manual

2.2 Using the Wizard for Basic Configuration

By default, the Setup Wizard will start once the DVR has loaded.
Steps:
1. Please select the system language in the drop-down list on your demand.
2. The Setup Wizard can walk you through some important settings of the DVR. If you do not want to use the
Setup Wizard at this time, click the Cancel button. You can also choose to use the Setup Wizard next time by
leaving the "Start wizard when device starts?" checkbox in checked status.
3. Click Next button on the Wizard window to enter the Login window.
4. Enter the admin password. By default, the password is 000000.
NOTE
You are highly recommended to change the default password right after the first login to avoid safety
problem.
5. To change the admin password, check the New Admin Password checkbox. Enter the new password and
confirm the password in the given fields.
6. Click the Next button to enter the date and time settings window, as shown in Figure 2. 6.
7. After the time settings, click Next button which will take you back to the General Network Setup Wizard
window.
NOTE
1 self-adaptive 10M/100M
10M/100M/1000M network interfaces for DS-8100HQHI&HGHI-SH series, and three working modes are
configurable: multi-address, load balance, network fault tolerance; and 1 self-adaptive 10M/100M/1000M
network interface for other models.
8. Click Next button after you having configured the network parameters, which will take you to the
Advanced Network Setup Wizard window.
9. Set the parameters of port NoAuto UPnP or DDNS if required.
10. Click Next button after configuring the advanced network parameters, which will take you to the HDD
Management window.
11. To initialize the HDD, click the Init button. Initialization will remove all the data saved in the HDD.
12. Click Next button to enter the Record Settings window, as shown in Figure 2. 10.
13. Click Copy to copy the recording setting to other cameras.
14. Click OK to save the settings and exit the wizard.
network interface is provided
19
for DT-E & DT-P 2 self-adaptive