Asus Ws C621E Sage - Matrox Mura IPX Series System Builder's Manual

ASUS WS C621E SAGE

Validated
Maximum number of cards
supported
Maximum supported
Mura IPX Series
Maximum supported
D-Series
Motherboard
Chipset
Processor
Heatsink (for CPU)
System BIOS version
System memory
Chassis
Power supply
PCIe expansion slots
Notes
Configurations
Slot
PCIEX16_1
PCIEX16_2
PCIEX16_3
PCIEX16_4
PCIEX16_5
PCIEX16_6
PCIEX16_7
54 Matrox Display Wall – System Builder's Guide
D-Series based controllers
Yes
7
6
4
ASUS WS C621 SAGE
Intel C621
Intel® Xeon® Bronze 3104 Dual CPU @ 1.70 GHz, or
Intel® Xeon® Silver 4210R Dual CPU @ 2.40 GHz
LGA 3647
6102, 2019-12-17
32 GB DDR4 ECC-RDIMM
Chenbro RM41300-FS81
850 W (P/N:EVGA Supernova 850G3)

3 PCIe ×16 3.0 slots (×16 mechanical, ×16 electrical)

2 PCIe ×16 3.0 slots (×16 mechanical, ×16 / ×8 electrical)

2 PCIe ×16 3.0 slots (×16 mechanical, ×8 electrical)

The chassis must be ordered from Chenbro. Power supply isn't included with the chassis.

Only the front chassis fan that comes with the Chenbro chassis must be changed to 120 mm x 120 mm x
25 mm 113 CFM.

The chassis fans must run at full speed. To change the fan speed, go to the system BIOS main page (EZ
 QFan Control 
mode) select
to and apply the changes.
Full Speed

The dust protection filter in the front door must be removed for proper system ventilation.

To use the on-board graphics, make sure the
install the VGA bracket cable that comes with the motherboard in an empty slot and connect to the internal
VGA connector VGA_HDR1 on the motherboard.
  Platform Configuration  Miscellaneous Configuration 
In the system BIOS, go to
.
OFFboard

Make sure to have the following default settings for Above 4G Decoding. In the system BIOS, go to
 PCI Subsystem Configuration

On-board console support with D-Series controller. Requires 3.05 or later drivers.
D-Series based controller
Main
D1480
MURAIPXI-E4JHF
D1480
MURAIPXI-E4JHF
D1480
MURAIPXI-E4JHF
D1480
Third-party based controllers
No foreseeable compatibility issues
select the header to which the fans are connected
3-pin VGA_SW1 jumper
, then set to
Above 4G Decoding
Third-party based controller
Option Main
B Third-party graphics hardware
A MURAIPXI-E4JHF
A, B Third-party graphics hardware
A MURAIPXI-E4JHF
A,B Third-party graphics hardware
A MURAIPXI-E4JHF
A, B Third-party graphics hardware

change from
is set to on the motherboard. Then,
Enable
then set
and set
Enabled First VGA 4G Decode
Standard
to
Active Video
Advanced
to .
Auto
Option
A
A
A
A
A
A