Supermicro C9Z390-Pgw - Matrox Mura IPX Series System Builder's Manual

Supermicro C9Z390-PGW

Validated
Maximum number of cards
supported
Maximum supported
Mura IPX Series
Maximum supported
D-Series
Motherboard
Chipset
Processor
Heatsink (for CPU)
System BIOS version
System memory
Chassis
Power supply
PCIe expansion slots
Notes
Configurations
Slot
CPU SLOT1 PCI-E 3.0 X8(IN X16)
CPU SLOT3 PCI-E 3.0 X 16
PCH SLOT4PCI-E 3.0x1
CPU SLOT5 PCI-E 3.0 X8(IN X16)
CPU SLOT7 PCI-E 3.0 X 16
Performance considerations with D-Series controller
Slot
CPU SLOT1 PCI-E 3.0 X8(IN X16)
CPU SLOT3 PCI-E 3.0 X 16
PCH SLOT4PCI-E 3.0x1
CPU SLOT5 PCI-E 3.0 X8(IN X16)
CPU SLOT7 PCI-E 3.0 X 16
70 Matrox Display Wall – System Builder's Guide
D-Series based controllers
Yes
4
3
4
Supermicro C9Z390-PGW
Intel Z390
Intel® Core™ i7-9700K CPU @ 3.60 GHz, 3600 MHz, 8 Core(s)
LGA 1151
1.0A, 2018-04-21
32 GB DDR4
Supermicro CSE-842XTQ
600 W redundant power supply

4 PCIe x16 3.0 slots (x16 mechanical, x16 / x8 electrical)

The chassis fans must run at full speed. To change the fan speed, go to the system BIOS main page
Monitor  Fan Control Setting 

In the system BIOS main page, go to
 Primary Display
to
IGFX
 Internal Graphics
to
Enabled

In the system BIOS main page, go to
Above 4G MMIO BIOS Assignment

On-board console support with D-Series controllers. Requires 3.05 drivers or later.
D-Series based controller
Main
D1480
MURAIPXI-E4JF
N/A
D1480
MURAIPXI-E4JF
Connectivity Configuration 1
x16 / x8 B*
x8 / x0 A
x1 N/A
x16 / x8 A
x8 / x0 A
Third-party based controllers
No foreseeable compatibility issues
and select .
Full Speed
Advanced  Graphics Configuration 
Advanced  PCIe/PCI/PnP Configuration  Option ROM execution 
to .
Enabled
Third-party based controller
Options Main
B Third-party graphics hardware
A, B MURAIPXI-D4JF
N/A N/A
A, B Third-party graphics hardware
A, B MURAIPXI-D4JF
Configuration 2
B*
A
N/A
B*
A
 H/W
and set:
and set
Options
A
N/A
A
A