Eca Evs-540-Asmb-815 - Matrox Mura IPX Series System Builder's Manual

ECA EVS-540-ASMB-815

Validated
Maximum number of cards
supported
Maximum supported
Mura IPX Series
Maximum supported
D-Series
Motherboard
Chipset
Processor
Heatsink (for CPU)
System BIOS version
System memory
Chassis
Power supply
PCIe expansion slots
Notes
Configurations
Slot
PCIEX1_Slot1
PCIEX4_Slot2
PCIEX8_Slot3
PCIEX16_Slot4
PCIEX8_Slot5
D-Series based controllers
Yes
5
4
4
Advantech ASMB-815
Part numbers: ASMB-815-00A1E / ASMB-815I-00A1E / ASMB-815T2-00A1E
Intel C621 / C622
Intel® Xeon® Silver 4210R CPU @ 2.40 GHz
LGA 3647
5.14, 2020-04-23
32 GB DDR4 ECC-RDIMM
4U
750 W

2 PCIe x16 3.0 slots (x16 mechanical, x16 / x8 electrical)

3 PCIe x8 3.0 slots (x8 mechanical, x8 electrical)

1 PCIe ×4 3.0 slot (×4 mechanical, ×4 electrical)

Requires two 120 mm x 120 mm x 25 mm 150 CFM chassis fans.

The dust protection sponge filter in front of the chassis must be removed for proper system ventilation
when the smart fan is enabled.

If you use a wired mesh filter in front of the chassis, the smart fan must be disabled. The chassis fans must
run at full speed.

Filter requires a 18 x 18 size 304 stainless steel wire mesh.
 Advanced  IT8528 HW Monitor Tab  Fan Configuration Tab 
In the system BIOS, go to
which the chassis fans are connected
 Enabled (when dust protection filter is removed)
 Disabled
(when wired mesh filter is present)
 Socket Configuration  IIO Configuration
In the system BIOS, select
:
[x8x8]

IOU1 (IIO PCIe Br2) [x8x8]

IOU2 (IIO PCIe Br3) [x8x8]
 In the system BIOS, select Advanced  PCI Subsystem Settings

On-board console support with D-Series controller. Requires 3.05 or later drivers.

Ensure to have the following settings for the GPU. In the system BIOS, go to
:
Devices
 VGA Priority
- Select
Auto
 Onboard VGA Controller
- Select
D-Series based controller
Main
N/A
N/A
MURAIPXI-E4JF
D1480
MURAIPXI-E4JF
Third-party based controllers
No foreseeable compatibility issues

and select the
Smart Fan Mode
, and change the following from
, and make sure
Enable
Third-party based controller
Options Main
N/A
N/A
A MURAIPXI-E4JF
B Third-party graphics hardware
A, B MURAIPXI-E4JF
Matrox Display Wall – System Builder's Guide
select the header to
:
[Auto]
is enabled.
Above 4G Decoding
Platform Configuration  PCH
Options
A
A
to
19