Asus Ws C422 Sage 10G - Matrox Mura IPX Series System Builder's Manual

ASUS WS C422 SAGE 10G

Validated
Maximum number of cards
supported
Maximum supported
Mura IPX Series
Maximum supported
D-Series
Motherboard
Chipset
Processor
Heatsink (for CPU)
System BIOS version
System memory
Chassis
Power supply
PCIe expansion slots
Notes
Configurations
Slot
PCIEX16_1
PCIEX16_2
PCIEX16_3
PCIEX16_4
PCIEX16_5
PCIEX16_6
PCIEX16_7
Performance considerations with D-Series controller
Slot Connectivity
PCIEX16_1 x16
PCIEX16_2 x8 / x4
PCIEX16_3 x16 / x8
PCIEX16_4 x8 / x0
PCIEX16_5 x16 / x8
PCIEX16_6 x8 / x0
PCIEX16_7 x16 / x8
60 Matrox Display Wall – System Builder's Guide
D-Series based controllers
Yes
7
6
4
ASUS WS C422 SAGE/10G
Intel C422
Intel® Xeon W-2123 CPU @ 3.6 GHz
LGA 2066
3203, 2020-06-10
32 GB DDR4 RDIMM
Chenbro RM41300-FS81
850 W (P/N:EVGA Supernova 850G3; use with Chenbro RM41300-FS81)

7 PCIe x 16 3.0 slots (x16 mechanical, x16 / x8 electrical)

The chassis must be ordered from Chenbro. Power supply isn't included with the chassis.

The chassis fans must run at full speed. To change the fan speed, go to the system BIOS main page (EZ
 QFan Control 
mode) select
to and apply the changes.
Full Speed

Ensure to have the following settings for Above 4G Decoding. In the system BIOS, go to
, then set
Boot Above 4G Decoding
D-Series based controller
Main
D1480
MURAIPXI-E4JHF
D1480
MURAIPXI-E4JHF
D1480
MURAIPXI-E4JHF
D1480
Configuration 1 Configuration 2 Configuration 3
B B
A A
A A
A A
A B*
A A
A A
Third-party based controllers
No foreseeable compatibility issues
select the header to which the fans are connected
to and set
ON First VGA 4G Decode
Third-party based controller
Option Main
B Third-party graphics hardware
A MURAIPXI-E4JHF
A, B Third-party graphics hardware
A MURAIPXI-E4JHF
A,B Third-party graphics hardware
A MURAIPXI-E4JHF
A, B Third-party graphics hardware
B
A
B*
A
B*
A
A

change from
Advanced Mode 
to .
Above_4G
Option
A
A
A
A
A
A
Configuration 4
B
A
B*
A
B*
A
B*
Standard