Ikegami HDK-65C Operation Manual page 69

■ Removing the Fiber Cable
This section explains how to remove the fiber cable.
CAUTION:
When you remove the cable, be sure to hold the plug and pull. Failure to do so may damage the fiber in the cable.
● Camera
● CCU
CCU-970 rear view
1
Remove the cable from the camera while pulling the unlocking ring on the fiber cable plug (female) toward you.
If the connector tip is locked, the fiber cable will not be removed. If it is locked, push the fiber cable toward the CAMERA
connector, and then remove as described above.
2
Remove the cable from the CCU-970 while pushing the unlocking ring of the CAMERA connector on the rear of
CCU-970.
If the connector tip is locked, the fiber cable will not be removed. If it is locked, push the fiber cable toward the CAMERA
connector, and then remove as described above.
Camera rear view
CAMERA connector
(male)
CAMERA connector (female)
Unlocking ring
HDK-65C 1501 VER1 (U)
3.5 CCU Connection
Unlocking ring
Plug (female)
Fiber cable
Plug (male)
Fiber cable
3
53