Table of Contents
Advertisement
Conductor:
AWG
Stranding
18
Solid
Shield Material
Type
Layer
Tape
1
Braid
2
Nom. Capacitance
Conductor to shield
16.2 pF/ft
Obtain Signal
The camera can simultaneously have SDI video output and HDMI video output and IP video output.
Video Signal
HDMI HD Video signal
1. Connect the camera to a HD monitor/TV using HDMI cable.
2. Turn on the camera, video will display on the monitor after running initializing.
3. Information of the camera initial setting status will display for 5 seconds.
4. You can set the video format of the camera to the one you want to display.
SDI Video Signal
The camera can simultaneously stream SDI video output with HDMI video output.
1. Connect SDI cable in between the camera your SDI Device/display.
2. You now have SDI video output.
3. SDI video only supports 1080P.
IP Video Signal
The camera can simultaneously stream IP video output and SDI video output and HDMI video output.
1. Connect the camera to the network using Cat5/Cat6 network cable.
2. You need to have a web browser or VMS client software ready for IP video streaming.
3. PELCO address and Baud Rate setting on the camera must be as same as the setting on camera IP WEB
interface.
4. To obtain IP video and configure IP video, please refer to Network Camera User Manual Part Two.
CVBS Video Signal
1. Connect CVBS cable in between the camera and your CVBS Device/display.
2. You now have CVBS video output.
Audio IN / OUT
•
On rear panel, a microphone or audio source can be connected to the Audio
IN port, which feeds audio into the camera
•
A speaker can be connected to the Audio OUT port, which will output any
audio that is captured on the Audio In port
•
See Manual part 2 for more information about Audio capture
•
Audio Line-in is embedded with camera HDMI, SDI and IP video signal.
Material
Nominal Diameter
Bare Copper
0.04 in.
Material
Aluminum / Polyester / Aluminum
Tinned Copper
Nom. Inductance
0.106 µ H/ft
Coverage
100%
95%
Nom. Char. Impedance
75 Ohm
14
Advertisement
Table of Contents
