Obtain Video Signal - Bolin Technology 2 Series User Manual

Conductor:
AWG Stranding
18 Solid
Shield Material
Type Layer
Tape 1
Braid 2
Nom. Capacitance
Conductor to shield
16.2 pF/ft

Obtain Video Signal

The camera can simultaneously have SDI video output and HDMI video output and IP video output.
HDMI HD Video signal
1. Connect the camera to a HD monitor/TV using HDMI cable.
2. Turn on the camera, video will display on the monitor after running initializing.
3. Information of the camera initial setting status will display for 5 seconds.
4. You can set the video format of the camera to the one you want to display.
SDI Video Signal
The camera can simultaneously stream SDI video output with HDMI video output.
1. Connect SDI cable in between the camera your SDI Device/display.
2. You now have SDI video output.
3. SDI video only supports 1080P.
IP Video Signal
The camera can simultaneously stream IP video output and SDI video output and HDMI video output.
1. Connect the camera to the network using Cat5/Cat6 network cable.
2. You need to have a web browser or VMS client software ready for IP video streaming.
3. PELCO address and Baud Rate setting on the camera must be as same as the setting on camera IP WEB
interface.
4. To obtain IP video and configure IP video, please refer to Network Camera User Manual Part Two.
USB Video Signal
This camera supports USB2.0 only.
System Requirements for your PC
1. Operating System: Microsoft Windows 10/Windows 8/Windows 7, Linux Ubuntu 16.04LTS, macOS Sierra,
Microsoft Windows 7 (32-bit) or above is recommended.
5. CPU: 2.0 GHz or higher, dual-core. Intel i3 CPU or higher are recommended.
6. Memory: At least 1 GB. 2 GB (or higher) is recommended.
7. Graphic Card: At least 128 MB display memory. Mainstream discrete graphics with more than 1 GB display
memory are recommended. Make sure that the latest driver is installed on graphic card.
8. Sound Card: The intercom and voice broadcast require the latest driver on sound card.
9. Network Card: Gigabit Ethernet network cards (or higher) are recommended.
Material Nominal Diameter
Bare Copper 0.04 in.
Material
Aluminum / Polyester / Aluminum
Tinned Copper
Nom. Inductance
0.106 µH/ft
Coverage
100%
95%
Nom. Char. Impedance
75 Ohm
11