Gamma; Network - Bolin Technology BC-7 Series User Manual

When the image stabilizer function is set to ON, you can obtain the image with less screen blur caused by
shaking. The correction effect can be achieved at the vibration frequency around 10 Hz. The image stabilizer
function uses the digital zoom method. Although there are changes in the angle of view and resolution, the
sensitivity is maintained.
Note: The image stabilizer function may not work under the environment of high frequency vibration
components. When using the camera under such environment, set the image stabilizer function to Off.

GAMMA

You can choose the type of basic curve for GAMMA
correction.
STANDARD: Standard setting (same as the MOVIE
setting on the camera).
STRAIGHT: This selects a straight GAMMA curve.
PATTERN: You can choose a gamma curve from 512
patterns stored in the camera. You can specify the
pattern out of 512 patterns using PATTERN and
PATTERN FINE. PATTERN defines the upper two
digits of the pattern, and PATTERN FINE defines the
last digit.
PATTERN: Choose a value from 0 to 51. This can be
chosen When SELECT is PATTERN.
PATTERN FINE: Choose a value from 0 to 9. When PATTERN is 0, 0 cannot be chosen for PATTERN FINE.
When PATTERN is 51, a value larger than 2 cannot be chosen for PATTERN FINE. This can be chosen when
SELECT is PATTERN.
OFFSET: You can choose the offset of the output level of gamma curves. Choose a value from –64 to 0 to +64.
LEVEL: Gamma level, you can choose a level value from -7 to 0 to +7.
BLACK GAMMA: You can adjust the black gamma level to recreate gradation in the dark areas of the picture
or to suppress noise with black-out. Choose a value from –7 to 0 to +7.
BLACK GAMMA RANGE: You can adjust the brightness range for which BLACK GAMMA becomes effective.
Choose from LOW,
MIDDLE, and HIGH. The range becomes small when LOW is chosen, and it becomes large when HIGH is
chosen.
BLACK LEVEL: You can adjust the master BLACK LEVEL. Choose a value from –48 to 0 to +48.
VISIBILITY ENHANCER (VE)
Depending on the imaging scene, the Visibility Enhancer function makes the darker part of a camera image
brighter, and automatically correct brightness and contrast to show bright parts clearly.

NETWORK

It may take a short while to display the network
information after you select the NETWORK menu.
The network menu is for displaying IP configuration
information of the IP encoder that is built-in with the
camera.
The IP configuration is currently not available to be
modified via OSD menu. You need to use your PC
internet browser to configure the IP network setting of the camera.
OSD
EXPOSURE
WHITE BALANCE
DETAIL
PICTURE
>GAMMA
NETWORK
PAN TILT ZOOM
>SYSTEM
OSD
EXPOSURE
WHITE BALANCE
DETAIL
PICTURE
GAMMA
>NETWORK
PAN TILT ZOOM
>SYSTEM
44
GAMMA MENU
GAMMA STANDARD
PATTERN 51
PATTERN FINE 2
OFFSET 0
LEVEL 0
BLACK GAMMA 0
BLACK GAMMA RANG LOW
BLACK LEVEL 0
VISIBILITY ENHANCER OFF
NETWORK MENU
IPv4 192.168.002.234
SUBNET MASK 255.255.255.0
GATEWAY 192.168.002.001
MAC ADDRESS 00:26:C2:01:02:EE