Bolin Technology BC-7 Series User Manual page 5

Best effort has been made to verify the integrity and correctness of the contents in this document, but no statement, information,
or recommendation in this manual shall constitute formal guarantee of any kind, expressed or implied. We shall not be held
responsible for any technical or typographical errors in this manual.
The product appearance shown in this manual is for reference only and may be different from the actual appearance of your
device.
This manual is a guide for multiple product models and so it is not intended for any specific product.
In this manual, the illustrations of displayed interface, parameters displayed, drawings and value ranges may vary with models.
Please see the actual product for details.
Due to uncertainties such as physical environment, discrepancy may exist between the actual values and reference values
provided in this manual.
Use of this document and the subsequent results shall be entirely on the user's own responsibility.
Symbols
Symbol
WARNING!
CAUTION!
NOTE!
Safety Information
WARNING!
Installation and removal of the unit and its accessories must be carried out by qualified personnel. You must read all of
the Safety Instructions supplied with your equipment before installation and operation.
Warnings:
•
If the product does not work properly, please contact your dealer. Never attempt to disassemble the camera yourself.
(We will not assume any responsibility for problems caused by unauthorized repair or maintenance.)
•
This installation should be made by a qualified service person and should conform to all the local codes.
•
When shipping, the camera should be packed in its original packaging.
•
Make sure the power supply voltage is correct before using the camera.
•
Do not drop the camera or subject it to physical shock.
•
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a bit of ethanol and wipe it
gently. If the camera will not be used for an extended period of time, put on the lens cap to protect the sensor from dirt.
•
Do not aim the camera lens at the strong light such as sun or incandescent lamp. The strong light can cause fatal
damage to the camera.
Maintenance Precautions:
•
If there is dust on the front glass surface, remove the dust gently using an oil-free brush or a rubber dust blowing
ball.
•
If there is grease or a dust stain on the front glass surface, clean the glass surface gently from the center outward
Contains important safety instructions and indicates situations that may cause bodily injury.
User must be careful and improper operations may cause damage or malfunction of product.
Indicates useful or supplemental information about the use of product.
Description
5