Operating Multiple Cameras With Infrared Remote Controller; Adjusting The Camera Focus - Bolin Technology BC-7 Series User Manual

When the STANDBY lamp is blinking
If the camera is moved forcibly, or a finger or other object interferes with camera movement, the camera may fail to
memorize the pan/tilt position.
Press the PAN-TILT RESET button to reset the pan/tilt position.
Zooming
Button (Slow Zoom) [T] - Zoom-IN and [W] - Zoom-OUT slowly
Button (Fast Zoom) [T] - Zoom-IN and [W] - Zoom-OUT quickly

Operating Multiple Cameras with Infrared Remote Controller

1. Set the DIP Switch on the rear panel of the camera to the number of camera you
want to operate to 1, 2 or 3.
(See DIP Switch setting instruction)
2. Press one of the Camera IR ID button on the IR remote controller, the button will
be illuminated, that means the camera that is set to IR ID Number will respond to
the IR controller.
3. Always firstly check if the IR ID is set correctly same as the IR ID set on the
camera when the camera is not responding to the IR controller.
Then, you can operate the camera(s) specified by number. Every time you operate the
camera(s) using the IR remote controller, the Camera IR ID button pressed in step 2
fleshes.

Adjusting the Camera Focus

Focusing on a Subject
Focusing the camera on a subject automatically
Press the AUTO button.
The camera focuses on the subject at the center of the screen
automatically.
Focusing the camera on a subject manually
After pressing the MANUAL button, press either the FAR or
the NEAR button to have the camera focus on the subject.
Shooting with Back Lighting
When you shoot a subject with a light source behind it, the
subject becomes dark. In such a case, press the BACK
LIGHT button.
To cancel the function, press the BACK LIGHT button again.
Note
The BACK LIGHT function is effective if MODE is set to
FULL AUTO in the EXPOSURE menu of the camera.
50