Table of Contents
Advertisement
1. Front Tally Light
2. IR Remote Controller Sensors
These are sensors to receive commands from infrared remote controller.
3. Lens
This is a 20X magnification optical zoom lens of 4K image
4. Power LED Indicator
Turns green when the camera is connected to power outlet. When the power is turned on, it takes about 15 to 30
seconds to display the image after LED turns on.
5. Back Panel
6. –
7. 12V DC Power Port
Connect the supplied DC power adaptor and cord.
8. RJ45 Port for IP Network Video Streaming and IP Control
For VISCA over IP control and IP video streaming with POE (IEEE802.3bt) power input.
9. RJ45 Port for HDBaseT Video Output
For HDBaseT output, provides video, control, audio and IP video streaming/control including power to camera
transmit up to 80-100 meters over one CAT6 network cable.
10. HDMI Port (HDMI 1.4)
11. Micro SD Card Port
12. 6G/3G-SDI Video Output
13. External Synchronization/Genlock
14. Ground
15. USB2.0 Port
For firmware upgrade only
16. RS232 Control Port (RJ45)
RJ45 to RS232 convertor cable is provided.
17. RS-422 Control Port (RJ45)
RJ45 to RS422 convertor cable is provided
18. IR Remote ID Selector
Camera ID for IR remote controller
19. Audio Output/Input(Line-in/out)
20. Video Format Selector
For video format selection
21. Bottom piece screws (Open them without authorization will violate warranty regulation)
22. Fix Mounting Holes
For original wall/ceiling mount bracket
23. Tripod mounting holes
24. Bottom DIP Switch
10
Advertisement
Table of Contents
